MCE 的所有产品仅用作科学研究或药证申报，我们不为任何个人用途提供产品和服务。

Sephadex G 25

CAS No. : 9041-35-4

MCE 国际站：Sephadex G 25

产品活性：Sephadex G 25 是一种葡聚糖层析介质。Sephadex G-25 分离范围为 1-5 kD (球形蛋白)，可用于多肽的分离以及大分子蛋白质的脱盐和缓冲液替换。

研究领域：Others

作用靶点：Others

In Vitro: Guidelines (Following is our recommended protocol. This protocol only provides a guideline, and should be modified according to your specific needs).
1. Swelling: The dry rubber particles need to be swelled for the first time. Place in excess deionized water and swell at room temperature for 3 h, or in a 90°C water bath for 1 h. (forbid to use magnetic stirring during the swelling process to avoid breaking the microspheres)
2. Column packing:
(1) Prepare initial buffer (equilibrium solution) and elution buffer according to the properties of the samples to be separated. In the case of desalting proteins such as proteins, it is generally recommended to use only one buffer with a low salt concentration for sample loading, equilibration and elution in gel chromatography. For example, 50 mM Tris-hydrochloric acid or PBS buffer near neutral; if it is the separation of peptides, 0.15 M NaCl can be appropriately added to shield the interaction between the target and the gel; if it is buffer exchange, select the target buffer as needed.
(2) Drain the gel, prepare a homogenate with initial buffer (at the ratio of gel:buffer = 3:1) and degas.
(3) Fix the column vertically, wet the bottom end with water or buffer and keep the liquid level for a period.
(4) Guide the homogenate with a glass rod and pour it into the column at one time along the inner wall of the column to allow the gel to settle freely in the column, seal the column with water, and settle overnight.
(5) Connect the movable column head at the top of the column, turn on the peristaltic pump, use the operating flow rate to let the buffer flow through 5 times the column volume, and then use 1.5 times the operating flow rate to flow through 5 times the column volume, and adjust the adapter head to make it as close as possible. Finally, equilibrate the column with 2-3 column volumes of buffer.
Note: Air bubbles cannot be introduced during all operations to ensure the uniformity of the gel.
3. Equilibration: Equilibrate the column with the equilibration buffer at the operating flow rate, and observe the change of the detector until the parameters such as conductivity and pH remain unchanged.
4. Loading: switch the switching valve to load the sample, and the sample load is selected according to the nature of the sample and the amount of the chromatography medium. Generally speaking, the sample load does not exceed 25% of the column bed volume. The samples were prepared with equilibration solution and pretreated by filtration with 0.45 μm microporous membrane.
5. Elution: Switch to elution buffer for constant elution, after peaking, to baseline equilibrium.
6. Regeneration: wash with 0.2 mol/L NaOH or non-ionic detergent for 2 times the column volume; then rinse with deionized water for 3-5 times the column volume.
7. Storage: After use, replace the mobile phase with 20% ethanol and store in a refrigerator at 4°C.
8. In order to obtain a better desalination effect, it is recommended to keep the column heights of different particle sizes at: 30 cm and above for coarse particles, 20 cm and above for medium particles, 10 cm and above for fine particles, 5 cm and above for ultra-fine particles, and The smaller the particle size, the higher the resolution and the slower the flow rate.
9. The amount of sample added should be determined according to the experiment. Generally, the maximum sample load does not exceed 30% of the column bed volume, and 10-20% is the best sample load.

相关产品：Bioactive Compound Library Plus  |  Antitumor agent-67  |  Catechin 7-O-β-D-glucopyranoside  |  Carbobenzoxyproline  |  ATR-IN-9  |  TBTDC  |  Peucenin 7-O-methyl ether  |  6-Hydroxy-4-methylcoumarin  |  AMT-NHS  |  Nylidrin hydrochloride  |  D-(+)-Fucose  |  OVA Peptide (323-339)  |  Secretin (swine)  |  Bletilloside A  |  Transcriptional Intermediary Factor 2 (TIF2) (740-753)  |  Pep-1 (uncapped)  |  Aspochalasin M  |  Dihydrofuran-3(2H)-one  |  2,6-Difluoropyridine  |  BPK-29 hydrochloride  |  pppApG  |  MEIS-IN-2  |  2′-O-Methyl-8-methyl guanosine  |  Altertoxin I  |  Lithospermoside  |  Acitazanolast  |  FLAG peptide  |  [Des-Tyr1]-Met-Enkephalin  |  α-Carotene  |  myo-Inositol trispyrophosphate hexa-triethylamine  |  Myt1-IN-2

热门产品线：重组蛋白  |  化合物库  |  天然产物  |  荧光染料  |  PROTAC  |  同位素标记物  |  寡核苷酸  |  抗体  |  点击化学

Trending products：Recombinant Proteins  |  Bioactive Screening Libraries  |  Natural Products  |  Fluorescent Dye  |  PROTAC  |  Isotope-Labeled Compounds  |  Oligonucleotides  |  Antibodies  |  Click Chemistry

品牌介绍:
•   MCE (MedChemExpress) 拥有200 多种全球独家化合物库，我们致力于为全球科研客户提供前沿最全的高品质小分子活性化合物；
•   50,000 多种高选择性抑制剂、激动剂涉及各热门信号通路及疾病领；
•   产品种类涵盖各种重组蛋白，多肽，常用试剂盒 ，更有 PROTAC、ADC 等特色产品，广泛应用于新药研发、生命科学等科研项目；
•   提供虚拟筛选，离子通道筛选，代谢组学分析检测分析，药物筛选等专业技术服务；
•   设有专业的实验中心和严格的质控、验证体系；
•   提供 LC/MS、NMR、HPLC、手性分析、元素分析等各项质检报告，确保产品的高纯度、高品质；
•   产品的生物活性多经各国客户实验验证；
•   Nature, Cell, Science 等多种顶级期刊及制药专利收录了MCE客户的科研成果；
•   专业团队跟踪最新的制药及生命科学研究进展，为您提供全球最新的活性化合物；
•   与世界各大制药公司及知名科研机构建立了长期的合作。